# How to Plan a CCTV System for a Retail Shop That Works

> Learn how to plan a CCTV system for a retail shop: where cameras go, how much resolution and storage you need, and how to get footage you can actually use.

Polynode Technologies | Hardware & IT | Published 2026-10-18
Read on the site: https://polynode.tech/insights/how-to-plan-a-cctv-system-for-a-retail-shop-that-works

Picture the owner of a busy general store. A customer swears a handbag went missing from the shelf near the entrance on Saturday afternoon. The owner opens the recorder, scrolls to the right hour and finds four grainy squares of video. The entrance camera points straight at the glass door, so every face is a white blur of daylight. The till camera shows the top of the cashier's head. The back-room camera works perfectly, which is no help at all. The one recording that mattered is useless, and the owner is left with a hunch instead of evidence.

The shop did have cameras. What it lacked was a plan for what those cameras needed to see. This guide explains how to plan a CCTV system for a retail shop so that the footage is there, and usable, on the day you need it.

In short: To plan a CCTV system for a shop, start from what you must be able to identify (faces at the entrance, hands at the till, stock at risk), then choose camera positions, resolution, wired power and enough storage for the number of days you want to keep, in that order. Buying cameras first and deciding on coverage afterwards is how shops end up with footage nobody can use.

## Why does so much shop CCTV footage turn out to be useless?

Back to our owner. A few years ago a relative installed a bundle of cameras, mounted wherever the cable was easiest to reach. Nobody asked what each camera was for. Over time the problems stacked up:

- Cameras faced bright doorways, so faces were lost in glare.
- Mounting was either so high that only the tops of heads were visible, or so low that a customer could reach up and turn the lens away.
- The recorder's disk filled up, so older footage was overwritten sooner than anyone realised.
- A lens had gathered dust and grease, and one cable had been nudged loose, so a camera had been blank for weeks without anyone noticing.

None of these are exotic faults. They come from treating CCTV as a box of gadgets rather than a small system with a job to do.

## What should you decide before choosing any camera?

Walk the shop with a notepad and write down three things.

1. **What must you be able to identify?** Usually this means the face of every person entering, the hands and the cash drawer at the till, and any shelf or storeroom where stock is most at risk.
2. **How long do you need to look back?** A theft is often discovered days later, during a stock count or when a customer complains. If your stock check happens weekly or monthly, a few days of storage will not be enough. Your insurer or local data-protection rules may also set expectations, so check those before you decide.
3. **Who will watch or review it?** If the owner reviews footage on a phone from home, the network matters. If it is only reviewed after an incident, a simpler setup may be enough.

These answers drive every later choice. Two shops with identical floor areas can need very different systems.

## Where should cameras go in a retail shop?

Installer guides agree on a simple order of priority: the entrance and the till first, then high-risk stock, then the rest.

- **Entrance:** Aim to capture faces as people walk in, not a straight shot into a bright doorway. Mounting a little to the side and at a sensible height helps avoid glare and gives you faces rather than the tops of heads.
- **Till:** Cover the counter so you can see both the transaction and the person on the other side of it. Some shops use a separate camera for the approach to the counter and another for the interaction itself.
- **Aisles and shelves:** Position cameras so they look along an aisle, not down at the floor, and cover blind corners behind tall shelves.
- **Storeroom and back door:** These are quiet places where losses often happen, and they deserve coverage even if customers never go there.

Keep cameras out of reach of tampering, and think about lighting. A camera cannot record what the room does not light, and night-time footage depends on both the camera and the lighting around it.

## How much resolution do you really need?

More is not always better. Higher resolution gives you more detail to identify a face or read a label, but it also produces larger files that need more storage and more network capacity. A practical approach is to put your higher-resolution cameras where identification matters most, at the entrance and the till, and use more modest cameras for general overview of aisles. Low-light performance matters at least as much as the headline resolution figure, because many shops operate in dim light or after dark.

## IP cameras, wiring and power: what is simplest to run?

Most new shop systems use IP cameras connected by network cable to a recorder. Many use power over Ethernet, where a single cable carries both power and video, which means fewer wires, one cable per camera and tidier installation. Wired connections are generally more dependable than wireless ones for cameras that must record continuously.

Two habits save trouble later:

- Keep the camera network separate from the network your point-of-sale and office computers use, so a camera is never a doorway into your business data.
- Plan the cable routes and the recorder location properly. A recorder in a hot, dusty cupboard behind the counter tends to fail early.

## How do you work out storage?

Storage is where many plans quietly go wrong. The method is straightforward: decide how many days you want to keep, then size the disk capacity to match. Continuous recording on every camera needs far more capacity than recording only when motion is detected, and higher resolution cameras need more than modest ones. A supplier can calculate this from your camera count and retention target. If you are unsure, it is safer to plan for more days than you think you will need, because the penalty for too little storage is overwritten evidence.

## What changes when it is done properly?

Return to the owner, a year later. The entrance camera now sits off to the side and catches every face. The till camera shows the counter clearly. The recorder holds enough days of footage to cover the gap between a theft and the weekly stock count. And once a month, someone checks that every camera is live and the lenses are clean. When a customer reports a missing item, the owner finds the moment in minutes, and the conversation ends with facts instead of arguments. The change was not more cameras. It was a plan.

## Frequently asked questions

### How many cameras does a small shop need?
It depends on the layout, not the shop's size. Cover the entrance, the till, any high-risk stock and the storeroom or back door first, then add overview cameras for aisles. A walk-through with a note of what you need to identify gives a more reliable number than any rule of thumb.

### How long should a shop keep CCTV footage?
Keep it long enough to cover the time between an incident and when you would normally discover it, such as your stock count cycle. Some insurers and data-protection rules also set expectations, so check those. Plan storage from the number of days you want, not the other way round.

### Should I choose wired or wireless cameras?
For cameras that must record all day, wired IP cameras with power over Ethernet are generally the more dependable choice, because they avoid signal drops and separate power supplies. Wireless can suit a spot that is hard to cable, but treat it as the exception.

## Which solution fits

Our shop owner's problem was never a lack of cameras; it was a lack of a plan and the right equipment behind it. The best fit is [Cameras & Surveillance](/services/cameras-surveillance). Polynode is an end-to-end IT company that supplies CCTV and IP camera systems with recorders and storage, sets them up to cover your premises, and supports them afterwards. The team quotes after understanding the requirement, starting with what you need to see and for how long. If the shop's network or cabling also needs attention, [IT Hardware & Devices](/services/it-hardware) covers the networking gear and cables. When you are ready, [talk to our team](/contact).

---

*Cover photo by [Scott Webb](https://unsplash.com/@scottwebb?utm_source=polynode&utm_medium=referral) on [Unsplash](https://unsplash.com/?utm_source=polynode&utm_medium=referral).*
